Unresolved V6 Hotend filament stuck in extruder

I got 45$ from robo3d store how much is e3d?


Sent from my iPhone using Tapatalk

 

Wow 71$ let me contact them to cancel problem is they are
Not replying even automated response message


Sent from my iPhone using Tapatalk

 

Yea I sent message after 10 days saying that if u won't response, I'll open a ticket with PayPal then they send me with an hour tracking number not shipped yet physically.


Sent from my iPhone using Tapatalk

 

Finally I got it I installed also but having small issue. It's not printing solid it's printing very loose.


Sent from my iPhone using Tapatalk

 

Hexagon I did not calibrate I'm going to do it now m


Sent from my iPhone using Tapatalk

 

I I printed calibration circle this what u were saying to do right ?

I printed calibration circle it's very thin





Sent from my iPhone using Tapatalk

 

Ohh thanks it's really clear what u were saying . Now going to follow Tom's instruction and calibrate I'll update here thanks


Sent from my iPhone using Tapatalk

 

Hi

i was following the steps when i mark the filament and test i fount its extruding filament less 10mm do i have to fix the value ?

G-Code

----------------------------
->M503
<-echo:Steps per unit:
<-echo: M92 X80.00 Y80.00 Z2267.72 E723.38
<-echo:Maximum feedrates (mm/s):
<-echo: M203 X500.00 Y500.00 Z5.00 E25.00
<-echo:Maximum Acceleration (mm/s2):
<-echo: M201 X9000 Y9000 Z100 E10000
<-echo:Acceleration: S=acceleration, T=retract acceleration
<-echo: M204 S1300.00 T3000.00
<-echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s)
<-echo: M205 S0.00 T0.00 B20000 X17.00 Z0.40 E5.00
<-echo:Home offset (mm):
<-echo: M206 X0.00 Y0.00 Z0.00
<-echoID settings:
<-echo: M301 P22.20 I1.08 D114.00
---------------------------

if have to fix the value in firmware where and how i can fix it ?