Unanswered Whats Wrong....

Orginal File http://www.thingiverse.com/thing:232464
So what is happening... When I print with Cura it fails... up closes it looks like the right side is not fused or stuck to the bed, middle is ok, and left is choppy. Mattercontrol works prefect....
Thoughts...
1. The bed is not level, G29 looks like this, if I'm reading it right the left side is high and the right is low, is this to far out of range for CURA
< Bed x: 15.00 y: 20.00 z: -0.74
< Bed x: 110.00 y: 20.00 z: 0.49
< Bed x: 205.00 y: 20.00 z: 1.45
< Bed x: 205.00 y: 125.00 z: 1.39
< Bed x: 110.00 y: 125.00 z: 0.57
< Bed x: 15.00 y: 125.00 z: -0.70
< Bed x: 15.00 y: 230.00 z: -0.20
< Bed x: 110.00 y: 230.00 z: 0.86
< Bed x: 205.00 y: 230.00 z: 1.76
< Eqn coefficients: a: 0.01 b: 0.00 d: -0.90
< planeNormal x: -0.01 y: -0.00 z: 1.00
< echo:endstops hit: Z:1.76
2. I'm missing something in the setup of Cura... MOST Likely... I tried to copy over every setting that I could match up.

Comments
Stan

 

is that the z-offset value?

 

yes it is