1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partially Solved X-Axis Issue

Discussion in 'Troubleshooting' started by BMiller, Aug 30, 2016.

Page 2 of 2
  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    wait ... so it does do the 9 point level ???
    Then this? Maybe you need a better video :)

    That could be the software screwed up then...
     
    #21 mark tomlinson, Aug 30, 2016
  2. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    And the fan under the printer is running? I've never seen this before so I am very curious what the issue is. So if you call Robo report back what it was.
     
    #22 danzca6, Aug 30, 2016
    mark tomlinson likes this.
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    I figured something wrong with the X axis completely, but if auto-leveling completes that is not the case.
    It might just be a badly configured slicer.
     
    #23 mark tomlinson, Aug 30, 2016
  4. BMiller

    BMiller New Member

    Joined:
    Aug 30, 2016
    Messages:
    11
    Likes Received:
    0
    Got it...thanks for your time on it :)
     
    #24 BMiller, Aug 30, 2016
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Yea, I would still call them on this. Out of the box MatterControl (of which I am not a fan) should be configured well enough this would not happen.
     
    #25 mark tomlinson, Aug 30, 2016
  6. BMiller

    BMiller New Member

    Joined:
    Aug 30, 2016
    Messages:
    11
    Likes Received:
    0
    Will do
     
    #26 BMiller, Aug 30, 2016
  7. BMiller

    BMiller New Member

    Joined:
    Aug 30, 2016
    Messages:
    11
    Likes Received:
    0
    It starts the 9 point level but hangs up in the process of it...it moved from home to the point you seen in the video then gets stuck there
     
    #27 BMiller, Aug 30, 2016
  8. Ryan TeGantvoort

    Ryan TeGantvoort Active Member

    Joined:
    Mar 11, 2016
    Messages:
    343
    Likes Received:
    172
    I don't think this is your issue, but just to clarify what are your numbers from the picture I have uploaded? I am assuming you are using MatterControl?
     

    Attached Files:

    #28 Ryan TeGantvoort, Aug 31, 2016
Page 2 of 2

Share This Page