x-y-z axises are not moving..

hi. i'v got something trouble after change the board.
but i don't know what to do.. T.T

at first.
if i click the bottons in 1 area in this picture.
x-y-z- axises are going home ( end-stop switch )
its moving well.

but!
if i click the bottons in the 2 area in this picture

nothing move... even motors...
only the silence.. T^T....


i think the name of my 3d printer is robo3d beta pla only..(not exact..i know it is just the early part model)

and i connect wires while see the tutorial..(but the wire connects are little bit different with my printer)

where is exact tutorial for wire connect? and what should i do? T^T


sorry for my English... plz help me..

 

I had a problem with my extruders thermister wires were getting worn. Also the thermister was coming loose from the extruder head I noticed that sometime when homing, my wires were getting crimped by hitting the z threaded axis rod. The end stop screw was too shallow. When it homed, it would sometime knock loose the thermister or even slightly pulled it out of the extruder head. The print would start but nothing moved. I could HOME but not lift the head or move it sideways.

After noticing the loose thermister, after putting it back in, then I restarted the printer, and reconnected. It then worked OK.

 

What does your printer show up as in the device manager?

 

upload a picture.
plz help me TT

 

I noticed that the temperatures are both reading 0C so I assumed it was a driver issue, but Arduino Mega 2560 is the correct driver...

Tell it to update the firmware and see what happens