1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Z axis drop during print R1+

Discussion in 'Troubleshooting' started by xfire_dragonx, Jun 2, 2018.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. xfire_dragonx

    xfire_dragonx Member

    Joined:
    Jun 2, 2018
    Messages:
    83
    Likes Received:
    13
    the high points are the model, never had this happen before.
    I'm now just using the cura 3.3.1, was using the robo cura 2.5.0, the software was the issue for the z axis fail on my prints.

    On the positive side, I have replacement fans and the boot for my heat block on the way.
    Added an exhaust fan to my printer.
     
    #21 xfire_dragonx, Jun 4, 2018
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Show us your first layer. It is probably too high off of the bed :) It should look like the picture in the link I posted.
     
    #22 mark tomlinson, Jun 5, 2018
  3. xfire_dragonx

    xfire_dragonx Member

    Joined:
    Jun 2, 2018
    Messages:
    83
    Likes Received:
    13
    20180605_092230.jpg Started this last night around 930pm -11 hrs later. I'm happy. Also did test cube in matter control with no issue and same with cura 3.3.1. also copied my gcode over from the robo cura. I think the cura robo software has an issue.
     
    #23 xfire_dragonx, Jun 5, 2018
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    All Robo did was create a profile. Other than that it is Cura :)
    That version may well have issues. Free though ...
     
    #24 mark tomlinson, Jun 5, 2018
  5. xfire_dragonx

    xfire_dragonx Member

    Joined:
    Jun 2, 2018
    Messages:
    83
    Likes Received:
    13
    Thanks for all the help from you and everyone else..
     
    #25 xfire_dragonx, Jun 5, 2018
    mark tomlinson likes this.
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page