1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved z off set problem (randomly appeared)

Discussion in 'Troubleshooting' started by lichaem69, Jan 7, 2016.

  1. lichaem69

    lichaem69 Member

    Joined:
    Apr 15, 2014
    Messages:
    71
    Likes Received:
    8
    I was able to print for a while pretty fine. I then took a break, and when i tried printing using repetier host, it appears the z off set is off. I haven't made any changes to it, and I tried using matter control, and it seems fine. I have an older R1 with no bed leveling. I couldn't really find how to change the offset in repetier and make it work. Can someone link me or explain how to fix this. Also if you know how to level a bed in repetier i would love to know (I leveled in mattercontrol and it seemed to carry over to repetier)
     
    #1 lichaem69, Jan 7, 2016
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Z offset is part of the start up gcode, likely when you switched to Repetier-Host the requisite M565 line in the start up code was not there.
     
    #2 WheresWaldo, Jan 8, 2016
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    If you don't have bed leveling don't use an offset. Are you sure you don't have bed leveling?
     
    #3 Mike Kelly, Jan 12, 2016

Share This Page