1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Z offset

Discussion in 'Troubleshooting' started by Jaak Ahelik, Aug 22, 2017.

  1. Jaak Ahelik

    Jaak Ahelik New Member

    Joined:
    Aug 22, 2017
    Messages:
    20
    Likes Received:
    8
    robo 3d r2 when unboxed, the z-offset nozzle moves to the left corner?
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,672
    Likes Received:
    7,318
    When powered on? Yes, it will startup in that corner.
    Once you launch a print it will move to the left front to start the autolevel probing of the bed as well as lay down a priming strip at the very front.
     

Share This Page