Recent Content by 2brosmanufacturing

Post

well I had a few mins this morning to mess around with it and was swapping around the cards and that did nothing for the issue. I did try the...

Post by: 2brosmanufacturing, Feb 16, 2016 in forum: Troubleshooting

Thread

Was running a print and the extruded started making horrible noises, stopped the print and checked it out, pulled the gears off to make sure...

Thread by: 2brosmanufacturing, Feb 15, 2016, 2 replies, in forum: Troubleshooting

Post

I just had the same issue with my r1 plus, half way through a print and it sounded like the gears where stripping, took the gears off and the...

Post by: 2brosmanufacturing, Feb 15, 2016 in forum: Troubleshooting

Post

So for doing larger parts it would be good but probably not for alot of the smaller parts.

Post by: 2brosmanufacturing, Feb 14, 2016 in forum: General Questions

Thread

Went and looked at another robo to sell to my brother to replace is prusa i3. Came with then e3d v6 and xxl along with a spare v6, and the...

Thread by: 2brosmanufacturing, Feb 13, 2016, 3 replies, in forum: General Questions

Thread

Once in a while and seems to be happening more frequently, the extruder runs full on in reverse forcing the filament back up and the head just...

Thread by: 2brosmanufacturing, Feb 8, 2016, 1 replies, in forum: Troubleshooting