Recent Content by J.P.

Thread

Normally the first thing I have to do with the Robo is connect to the hotspot the SSH into the Pi to harvest the MAC address so I can put it on...

Thread by: J.P., Jan 28, 2019, 1 replies, in forum: Troubleshooting

Thread

I'm curious to know if anyone else has had leveling problems with the R2. So the symptom i have is the first layer is trying to print too close...

Thread by: J.P., Jun 1, 2018, 3 replies, in forum: Troubleshooting

Thread

I have one of the v2 beds that connect directly to the cable instead of through the PoGo board. My problem is that things stick a little TOO well...

Thread by: J.P., Jan 24, 2018, 2 replies, in forum: Troubleshooting

Post

After muttering to myself "wtf..." for about 20 min, I discovered that. Thanks though, I will look up how to change it back, if that is even...

Post by: J.P., Nov 23, 2017 in forum: Troubleshooting

Post

So I found another person who uploaded a share folder containing a 1.6gig image file. I used Etcher to reimage my SDcard, plugged it back in and...

Post by: J.P., Nov 23, 2017 in forum: Troubleshooting

Post

Thank you for the links!

Post by: J.P., Nov 23, 2017 in forum: Troubleshooting

Post

No, I didn't think to backup the image it came with. I will contact support then and see what they have to say.

Post by: J.P., Nov 23, 2017 in forum: Troubleshooting

Thread

I have a black screen on my Robo R2 and i followed the directions in the FAQ but those directions are for a solid green light on your Raspberry...

Thread by: J.P., Nov 23, 2017, 7 replies, in forum: Troubleshooting