1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Jutte

  1. Jutte
    Post

    Starts out fine then goes crumbly

    Success[IMG] Sent from my SM-T733 using Tapatalk
    Post by: Jutte, Mar 1, 2022 in forum: Troubleshooting
  2. Jutte
    Post

    Starts out fine then goes crumbly

    I decided to purge some filament before trying again, and noticed that the extrusion was inconsistent. Checking the spool, I found that it was not...
    Post by: Jutte, Mar 1, 2022 in forum: Troubleshooting
  3. Jutte
    Post

    Starts out fine then goes crumbly

    Didn't help. Sent from my SM-T733 using Tapatalk
    Post by: Jutte, Mar 1, 2022 in forum: Troubleshooting
  4. Jutte
    Thread

    Starts out fine then goes crumbly

    Any suggestions what's going on here? The platform and first few layers print fine, then it goes spindly and crumbly. Doesn't seem to matter what...
    Thread by: Jutte, Feb 26, 2022, 8 replies, in forum: Troubleshooting
  5. Jutte
    Thread

    E3D Revo and R2

    Curious whether this hotend is compatible with the R2? I have arthritic hands and changing nozzles is difficult and painful....
    Thread by: Jutte, Feb 26, 2022, 1 replies, in forum: General Questions
  6. Jutte
    Thread

    Belt tension

    The tension on the belt on the left side of my R2 is much looser than the one on the right. Prints seem to be OK so far. Does this belt need to be...
    Thread by: Jutte, Sep 23, 2018, 2 replies, in forum: Troubleshooting
  7. Jutte
    Post

    Where is this from?

    Got it. Under Motor Controls performed -Z until I could get at them all.
    Post by: Jutte, Jul 15, 2018 in forum: Troubleshooting
  8. Jutte
    Post

    Where is this from?

    Figured it out, every single one of the screws that level the bed fell out. How should I raise the bed to replace them?
    Post by: Jutte, Jul 15, 2018 in forum: Troubleshooting
  9. Jutte
    Thread

    Where is this from?

    Better and better. What do you suppose this fell out of?
    Thread by: Jutte, Jul 15, 2018, 4 replies, in forum: Troubleshooting
  10. Jutte
    Post

    Extrusion problem

    Got a new thermistor under warranty and after several tries and cleanings I finally got the hotend to stop leaking. The flats on the threaded...
    Post by: Jutte, Jul 11, 2018 in forum: Troubleshooting
  11. Jutte
    Post

    Extrusion problem

    Note to self DO NOT replace the magnetic logo over the hot end until you have verified that it isn't leaking. That's the real reason for the bad...
    Post by: Jutte, Jun 30, 2018 in forum: Troubleshooting