1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by m.hunter509

  1. m.hunter509
    Post

    Prints not sticking/overall bad quality when it does

    Yeah the R2 is a little over a year old. I've adjusted the z-offset so it is too close to the bed and too far, each resulted in the same. Yeah the...
    Post by: m.hunter509, Nov 19, 2018 in forum: Troubleshooting
  2. m.hunter509
    Thread

    Prints not sticking/overall bad quality when it does

    I recently replaced the motherboard (due to wrong temp readings) and upgraded the bed to a V2 (after the infamous pogo pins failure). After that,...
    Thread by: m.hunter509, Nov 19, 2018, 24 replies, in forum: Troubleshooting
  3. m.hunter509
    Post

    Wrong temp readings for bed & extruder after replacing pogo pin board

    Support got back to me this morning and said they believe I need a new main board and most likely a new bed, and sent me the order for both parts....
    Post by: m.hunter509, Sep 13, 2018 in forum: Troubleshooting
  4. m.hunter509
    Post

    Wrong temp readings for bed & extruder after replacing pogo pin board

    Yeah the temps were all accurate until I replaced the pogo pin board. Support sent me the pogo pin board replacement after my last one went out,...
    Post by: m.hunter509, Sep 12, 2018 in forum: Troubleshooting
  5. m.hunter509
    Thread

    Wrong temp readings for bed & extruder after replacing pogo pin board

    After Robo sent me a new pogo pin board replacement (the previous one had the infamous multiple pins failure), my R2 is now giving the wrong temps...
    Thread by: m.hunter509, Sep 12, 2018, 5 replies, in forum: Troubleshooting