1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Pandariot779

  1. Pandariot779
    Thread

    Made and unboxing video of my Robo r2 and did initial set up

    [MEDIA] Hey I made an unboxing video and hope you guys like it. I also did a test print in the following video and the video after i printed out...
    Thread by: Pandariot779, Jun 3, 2017, 2 replies, in forum: Show and Tell
  2. Pandariot779
    Post

    Unresolved upgraded to e3dv6 but do not know what is happening!

    yes i am. i notice when i run prints at 200 degrees my temp jumps up and down between 190 - 210 degrees until the printer disconnects from the...
    Post by: Pandariot779, Sep 20, 2016 in forum: Troubleshooting
  3. Pandariot779
    Post

    Unresolved upgraded to e3dv6 but do not know what is happening!

    bah! the problem persist
    Post by: Pandariot779, Sep 19, 2016 in forum: Troubleshooting
  4. Pandariot779
    Post

    Unresolved upgraded to e3dv6 but do not know what is happening!

    i also wonder, what happens when you set your extruder amount to 2 in marlin but you only have one on your printer.
    Post by: Pandariot779, Sep 16, 2016 in forum: Troubleshooting
  5. Pandariot779
    Post

    Unresolved upgraded to e3dv6 but do not know what is happening!

    i reinstalled original firmware and original hotend and the pid test failed. so i believe it is the board... i just ordered a new board and a new...
    Post by: Pandariot779, Sep 16, 2016 in forum: Troubleshooting
  6. Pandariot779
    Post

    Unresolved upgraded to e3dv6 but do not know what is happening!

    yes i have, i am going to order a new board
    Post by: Pandariot779, Sep 15, 2016 in forum: Troubleshooting
  7. Pandariot779
    Post

    Unresolved upgraded to e3dv6 but do not know what is happening!

    i connected a different hot end adn a i connected a different hotend and themister and still get the same issue. I also reflashed and got the...
    Post by: Pandariot779, Sep 15, 2016 in forum: Troubleshooting
  8. Pandariot779
    Post

    Unresolved upgraded to e3dv6 but do not know what is happening!

    what would cause the printer to disconnect?
    Post by: Pandariot779, Sep 15, 2016 in forum: Troubleshooting
  9. Pandariot779
    Thread

    Unresolved upgraded to e3dv6 but do not know what is happening!

    after i installed my e3dv6 and flashed the firm ware my printer would not run PID auto tune correctly. i see when i run M303 E0 S210 C8 it will...
    Thread by: Pandariot779, Sep 15, 2016, 14 replies, in forum: Troubleshooting
  10. Pandariot779
    Thread

    After installing my E3d V6 I keep having issues, help

    after i installed my e3dv6 and flashed the firm ware my printer would not run PID auto tune correctly. i see when i run M303 E0 S210 C8 it will...
    Thread by: Pandariot779, Sep 15, 2016, 2 replies, in forum: Mods and Upgrades