Separate names with a comma.
Any luck finding the board?
I have already converted, but I'm just very unhappy with it. Prints are too hard to remove, some material is still on there and won't...
Geof, that would be greatly appreciated. If you find the Pogo pin board, I'll take it. (mine got damaged in a move, I believe . . . should have...
I would actually need the little board with the pins too. I was just going to build it up with solder or something, but if someone had that...
Anybody wanna sell their original R2 bed? The one that used to detach . . . .
My little spring contacts broke, and instead of a new one, they...
The new bed removes the ability to easily remove the bed at print complete. You'd have to pull the plug to remove the bed, and it's not easy to...
Looks great! Well done!
The dual head extruder module Robo3D is using on the home page to sell the R2 to people, making them think it comes with two print heads.
Anyone still have this working, or ever get it working? I can't find the "My Robo" skill on Alexa . . . . .
Will Robo be selling the updated fan shroud? I'd rather buy one than print one myself (seems counter-intuitive, I know)
Lexan Sheet - Polycarbonate - .030"
from amazon cut to fit.
I see all these methods to keep our filament in a dry environment.
What I notice when my filament spools sit out on the desk for a few months at...