1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Matthew P
    Thread

    R2 Not showing files on flash drive

    I am coming up with two different issues. One that I tried to resolve that causes the other. I have a 60gb flash drive that I have loaded with...
    Thread by: Matthew P, Feb 12, 2020, 2 replies, in forum: Troubleshooting
  2. Matthew P
    Post

    Z Offset Wizard Stopping at Step 1/4 with bed around 40mm away from extruding tip

    Resolved the issue. Changed the probe offset in EEPROM.
    Post by: Matthew P, Feb 11, 2020 in forum: Troubleshooting
  3. Matthew P
    Post

    Z Offset Wizard Stopping at Step 1/4 with bed around 40mm away from extruding tip

    Hey hey Mark thanks for the input! I tried setting the Z-Offset manually in the EEPROM to -10, -5, -4, -3, -2, -1, -0.5, -0.4, -0.3, -0.2, -0.1,...
    Post by: Matthew P, Feb 11, 2020 in forum: Troubleshooting
  4. Matthew P
    Thread

    Z Offset Wizard Stopping at Step 1/4 with bed around 40mm away from extruding tip

    Howdy everyone, New to the Robo3D machines. Using a gently used R2 unit and I was following the steps from the online quick start and reading the...
    Thread by: Matthew P, Feb 11, 2020, 5 replies, in forum: Troubleshooting
Showing results 1 to 4 of 4
Search Again