1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Joseph Stevens
    Thread

    Solved Heat sink fan not keeping up

    I'm having heat creep problems, and I think it's because the heat sink fan isn't spinning at full speed. Is there any fix for this or should I...
    Thread by: Joseph Stevens, Nov 3, 2019, 2 replies, in forum: Troubleshooting
  2. Joseph Stevens
    Thread

    I just want to replace the hot end.

    I can't wait for parts direct to get a new shipment, I just need a link to something I can order from Amazon, plug it into the R2 I've been...
    Thread by: Joseph Stevens, Sep 13, 2019, 30 replies, in forum: Mods and Upgrades
  3. Joseph Stevens
    Thread

    persistent ringing problem

    Apparently I can't upload photos for some reason. Printing from Cura 4.1 on a Mac. I've done the gantry alignment thing. Is there not a Robo R2...
    Thread by: Joseph Stevens, Jun 18, 2019, 6 replies, in forum: Troubleshooting
  4. Joseph Stevens
    Thread

    Advanced Variables

    What are the advanced variables under EEPROM? Does Z specify the nozzle size? The default value for Z is .4.
    Thread by: Joseph Stevens, Apr 30, 2019, 1 replies, in forum: General Questions
Showing results 1 to 4 of 4
Search Again