1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. tiagomaricate
    Post

    Serious Bed Homing Problem

    Wait... so the IR sensor actually is useless? There is no function?
    Post by: tiagomaricate, Jul 11, 2020 in forum: Troubleshooting
  2. tiagomaricate
    Post

    hotend hits the bed

    I was doing some tests with a new Buildtak (non-original) and have the same issue. The surface probably doesn't reflect the IR sensor. So I put a...
    Post by: tiagomaricate, Jul 11, 2020 in forum: Troubleshooting
  3. tiagomaricate
    Post

    Looking for suggestions to silent the printer

    Why? No much selling? About the board, does it use merlin? Maybe klippe? A friend told me it uses a rasp and an Arduino. Is that correct?
    Post by: tiagomaricate, Jul 9, 2020 in forum: General Questions
  4. tiagomaricate
    Post

    Robo R2/C2 replacement system board now available

    Where can I find it?
    Post by: tiagomaricate, Jul 9, 2020 in forum: Mods and Upgrades
  5. tiagomaricate
    Post

    Looking for suggestions to silent the printer

    hummmmm... good to know. Looks, unfortunately, the replacement board doesn't support dual extruder :( Don't make me choose! lol I will check the...
    Post by: tiagomaricate, Jul 9, 2020 in forum: General Questions
  6. tiagomaricate
    Post

    Looking for suggestions to silent the printer

    Got it... So basically if I change the drivers I have to change the mainboard... or use a bypass (like this one [MEDIA]) I will check these...
    Post by: tiagomaricate, Jul 9, 2020 in forum: General Questions
  7. tiagomaricate
    Thread

    Looking for suggestions to silent the printer

    I'd like to put the print in my office. But the noise emissions from the fans and drivers don't allow anybody to concentrate. I see some printer...
    Thread by: tiagomaricate, Jul 8, 2020, 15 replies, in forum: General Questions
  8. tiagomaricate
    Post

    Adding a Second Extruder

    Do you have any tutorials? I'm looking to add a second extruder also.
    Post by: tiagomaricate, Jul 8, 2020 in forum: General Questions
  9. tiagomaricate
    Post

    Robo 3D App is Gone IOS

    Thank you @mark tomlinson ! @tkoco I'm also curious... it's my first FDM print and it looks awesome, but this lack of information frustrates me.
    Post by: tiagomaricate, Jul 6, 2020 in forum: General Questions
  10. tiagomaricate
    Thread

    Where is the ios app

    Hi people! I was looking for the app but is not available on the Brazilian app store. So I asked for some guys to check if they can download the...
    Thread by: tiagomaricate, Jul 5, 2020, 2 replies, in forum: Software
Find older messages
Showing results 21 to 30 of 30
Search Again
Page 2 of 2