1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. colinbuck
    Profile Post

    Hi Mike I know you have wrote an in depth article on the E3D v6 hot end i've just bought one for...

    Hi Mike I know you have wrote an in depth article on the E3D v6 hot end i've just bought one for my robo 3d r1 plus, I just want to know if I use...
    Profile post by colinbuck for Mike Kelly, Oct 30, 2019
  2. colinbuck
    Thread

    Answered Printing wood pla

    Hi everyone i'm sure this has been asked many times before, printing wood pla on a robo 3d r1+ does anyone know the settings that work best with...
    Thread by: colinbuck, May 22, 2019, 1 replies, in forum: Troubleshooting
  3. colinbuck
    Post

    Octoprint .ini

    Hi what I'm trying to do is when I'm setting up octoprint initial setup and it asks to select a slicer and .ini file to import my printer settings...
    Post by: colinbuck, Oct 6, 2018 in forum: England
  4. colinbuck
    Thread

    Octoprint .ini

    Hi guys and girls help needed, I have recently setup octoprint on my robo 3d r1 plus, and it's running well my only issuie is, where do I find the...
    Thread by: colinbuck, Oct 1, 2018, 4 replies, in forum: England
  5. colinbuck
    Post

    Solved RepRap discount full graphic LCD help

    Yep I'm using arduino ide connection but since this is all new to me not quite sure what I'm doing within arduino and think I might have change...
    Post by: colinbuck, Mar 18, 2017 in forum: Troubleshooting
  6. colinbuck
    Post

    Solved RepRap discount full graphic LCD help

    Yep I followed that video also but got stuck at the part where he mentioned about the marlin firmware what is it and where do I get it from would...
    Post by: colinbuck, Mar 18, 2017 in forum: Troubleshooting
  7. colinbuck
    Thread

    Solved KOOKYE LCD 12864 Graphic Smart Display Controller module

    Hi guys I'm in need of some help i've just bought my lovely robo r1 +plus and it's my first 3d printer and I'm loving it so far I've also bought...
    Thread by: colinbuck, Mar 17, 2017, 2 replies, in forum: Troubleshooting
Showing results 1 to 7 of 7
Search Again