Separate names with a comma.
Is there a diagram that shows the gantry setup? Or can someone send me pics of each corner of the gantry. Trying to rebuild the gantry and need...
My hotbed for my R2 is shot. Keeps burning up the hotbed cable ! Is there anther hotbed that will work with the R2?
I am having a small issue which the extruder scratches the top of my print as it finishes. I was thinking the below g code would be correct to...
My last print was good a few weeks ago, I shut everything down and came back to the printer tonight. When I turned it on, everything thing seemed...
I am having a printing issue with my R2 Cura. When I load a project and I get a greyish ghost like image which the project when printed is shrunk...
Robo is out of the hotend/extruder for the R2, does anyone know where I can get the exact replacement?
Does any one know what's up with Robo3D? I mean their shop is out of a lot of items for a while now and no one is responding to emails or...
I need to replace the senor for the filament run out and the sensor for the bed leveling etc.?
Any one know what the R2 uses?
I get the following error every time I start Cura for my R2:
"error an exception occurred while parsing the json file"
Does any know how one would connect to the R2 RPI? Trying to connect Mosaic Canvas via OctoPrint and I can not seem to figure it out
When ever I print something, I have been getting this dimple like on the print. Its located in the same place for every individual print. If I was...