1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Replacement for sensors

Discussion in 'Troubleshooting' started by Paul1967, Apr 6, 2019.

  1. Paul1967

    Paul1967 Member

    Joined:
    Oct 27, 2018
    Messages:
    38
    Likes Received:
    1
    I need to replace the senor for the filament run out and the sensor for the bed leveling etc.?

    Any one know what the R2 uses?

    Thank you

    Paul
     
    #1 Paul1967, Apr 6, 2019
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    The R2 uses simple micro switches for both, so it should be easy to find replacements that will work.
     
    #2 WheresWaldo, Apr 6, 2019
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Bed leveling uses IR, and there is no replacement other than getting a new board direct from Robo
     
    #3 WheresWaldo, Apr 6, 2019
    mark tomlinson likes this.
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Yea, in theory you could replace the bits inside the IR sensor, but that would mean some disassembly and research. Better to see if Robo can source you one.
     
    #4 mark tomlinson, Apr 6, 2019
    Geof likes this.

Share This Page