1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 2 of 2
  1. eric tobin
    Thread

    Solved misc parts for robo r1+

    where can I get misc. parts, heater blocks, hotends, stepper motors etc
    Thread by: eric tobin, Sep 5, 2017, 6 replies, in forum: General Questions
  2. eric tobin
    Thread

    Solved set screws

    does anyone know what size and where to get the allen screws that are used to hold the thermistor and heating element in the head of the hotend?
    Thread by: eric tobin, Aug 28, 2017, 5 replies, in forum: Troubleshooting
  3. eric tobin
    Thread

    Solved 3cm fan

    In a previous thread Where's Waldo gave me a link for a adapter to use a 3 cm square fan. what is the fan I need to buy?
    Thread by: eric tobin, Aug 24, 2017, 7 replies, in forum: General Questions
  4. eric tobin
    Thread

    Solved replacing fan

    I have a robo r1+. finally figured out the fan issue I have been having is because the fan is going out. what would be best to replace it with? I...
    Thread by: eric tobin, Aug 23, 2017, 9 replies, in forum: General Questions
  5. eric tobin
    Thread

    Unanswered filament not being extruded

    OK, I did a good print fairly large and all came out good. started a new print this morning, same filament, got as far as the first couple of...
    Thread by: eric tobin, Aug 23, 2017, 1 replies, in forum: Troubleshooting
  6. eric tobin
    Thread

    Answered setting the fan

    is there some code or way to set the fan so it always turns on when your print starts, or am I missing something in the settings menu on how to...
    Thread by: eric tobin, Aug 21, 2017, 4 replies, in forum: General Questions
  7. eric tobin
    Thread

    Solved kinks

    ok, I got my new hot end first several prints were good, now I seem to be getting a kink in the filament at the top. At least that is what it...
    Thread by: eric tobin, Aug 19, 2017, 7 replies, in forum: Troubleshooting
  8. eric tobin
    Thread

    robo service

    has anyone ever had trouble getting a hold the sales department? I purchased a hotend mon. paid 2 day air, and it still is not here! every time I...
    Thread by: eric tobin, Aug 17, 2017, 4 replies, in forum: General Questions
  9. eric tobin
    Thread

    Solved using flexible filament

    any tips or ideas on using flexible filament? where to look?
    Thread by: eric tobin, Jul 29, 2017, 1 replies, in forum: Troubleshooting
  10. eric tobin
    Thread

    what makes the bed chip?

    printed a part last night, woke up this morning took off the part, it was real sticky in one spot, got it up and had glass on the bottom. usually...
    Thread by: eric tobin, Jul 27, 2017, 2 replies, in forum: General Questions
  11. eric tobin
    Thread

    Solved cannot remove extruder

    there are no screws where there should be. extruder is being held by something but I cant find it, need to remove to unjam fillament
    Thread by: eric tobin, Jul 21, 2017, 7 replies, in forum: Troubleshooting
Find older messages
Showing results 21 to 31 of 31
Search Again
Page 2 of 2