1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Shberfet
    Thread

    Solved Printer Under extruding in certain areas

    I have been having a very strange issue with my printer where in will under extrude in a certain area of the print but be relatively normal every...
    Thread by: Shberfet, Feb 6, 2017, 2 replies, in forum: Troubleshooting
  2. Shberfet
    Thread

    Solved Extruder damaged

    I started an over night print that was only a few hours long but when I saw it this morning it had a massive glob of filamint around the extruder...
    Thread by: Shberfet, Nov 23, 2016, 3 replies, in forum: Troubleshooting
  3. Shberfet
    Post

    Unresolved Robo 3D R1 Connection lost

    I have my computer set up so that it never shuts down while printing and it would disconnect while I was watching its progress on the computer. I...
    Post by: Shberfet, Nov 22, 2016 in forum: Troubleshooting
  4. Shberfet
    Thread

    Unresolved Robo 3D R1 Connection lost

    I recently started a 30 hour print and after about 25 hours, the print stopped and said the connection was lost:mad:. I thought the USB cable just...
    Thread by: Shberfet, Nov 21, 2016, 3 replies, in forum: Troubleshooting
  5. Shberfet
    Thread

    Solved My 3D printer keeps printing off the heatbed

    Are the print-areas supposed to be bigger than the actual heat-bed on Robo 3D printer? Every time I want to print something that takes up most of...
    Thread by: Shberfet, Sep 22, 2016, 2 replies, in forum: Troubleshooting
  6. Shberfet
    Thread

    Unresolved Different layers aren't lining up

    I have been successfully printing great pieces all week, but for some reason it is now printing the layers in-aligned with the ones below them....
    Thread by: Shberfet, Mar 9, 2016, 2 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again