1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Larry H
    Thread

    Solved Scars in Walls

    hello, I replaced my hotend with a new stock hotend from robo. After a lot of retreating and dialing I thought I had it but. No matter what I try...
    Thread by: Larry H, Sep 26, 2017, 15 replies, in forum: Troubleshooting
  2. Larry H
    Thread

    Solved Extruder multiplier question

    Hi, In running the test for under/over extrusion I found for 100mm it's only printing out about 90mm. After I try a atomic pull tonight to clean...
    Thread by: Larry H, Jul 14, 2016, 34 replies, in forum: Troubleshooting
  3. Larry H
    Thread

    Firmware Version Question

    Hello, So I've been having some issues recently with my Robo3D R1+ printer. I have another post or two about that open but this is better suited...
    Thread by: Larry H, Jul 13, 2016, 15 replies, in forum: Software
  4. Larry H
    Thread

    Unresolved Simplify3d Calibration issues

    Hello, I had posted a similar issue before but that was when I only had MatterControl. I finally bought Simplify3d and after many initial issues...
    Thread by: Larry H, Jul 12, 2016, 5 replies, in forum: Troubleshooting
  5. Larry H
    Thread

    Solved Printing blob issue

    Hello, First thing is I'm using a Robo 3D R1+ After my thermistor issue this past weekend I re-calibrated my printer and have been trying to print...
    Thread by: Larry H, Jun 1, 2016, 50 replies, in forum: Troubleshooting
  6. Larry H
    Thread

    Solved Error: Extruder Turned off Mintemp Triggered

    The start of this issue was I had a clog in my Robo 3d R1+ printer, after carefully removing the hotend I was able to heat it up and clear the...
    Thread by: Larry H, May 30, 2016, 17 replies, in forum: Troubleshooting
  7. Larry H
    Thread

    Unanswered PLA prep

    hello, So as still a newbie 3d printer I was wondering for printing with PLA right on the printer bed. What temperature has people found works...
    Thread by: Larry H, Feb 7, 2016, 2 replies, in forum: General Questions
Showing results 1 to 7 of 7
Search Again