1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. castmemberzack
    Thread

    ABS Troubles with ABS

    I'm getting stuff like this: http://imgur.com/a/z3QUb Hatchbox, R1+, S3D. Here's the file: http://www.thingiverse.com/thing:317788
    Thread by: castmemberzack, Aug 5, 2016, 12 replies, in forum: Printing Filament
  2. castmemberzack
    Thread

    Unanswered Hex fan isn't working.

    I just ordered a new one, and it does the same thing. I pull on the black plastic tube that houses all the wires in a certain direction, it works....
    Thread by: castmemberzack, Jul 21, 2016, 4 replies, in forum: Troubleshooting
  3. castmemberzack
    Thread

    Unanswered Getting bumps on ABS that throw off my extruder

    http://m.imgur.com/Qv2kWqbkWqb The middle and outside of the prints are fine. It's when it gets to those edgez that it lifts up on one side and...
    Thread by: castmemberzack, Jul 14, 2016, 0 replies, in forum: Troubleshooting
  4. castmemberzack
    Thread

    Unanswered Edges are warping up.

    I've tried turning the plate and extruder temp down. Extruder temp is at 190 and plate was at 50. http://imgur.com/a/CA74G Everything's being...
    Thread by: castmemberzack, Jun 27, 2016, 11 replies, in forum: Troubleshooting
  5. castmemberzack
    Thread

    Unanswered Layers aren't being finished

    http://imgur.com/9OdzlZUOdzlZU I can't really explain it. The infill is at 90%. I tried upping the top layers, shells, extrusion multiplier, and...
    Thread by: castmemberzack, May 19, 2016, 206 replies, in forum: Troubleshooting
  6. castmemberzack
    Thread

    Unresolved "Printer stopped due to errors. Fix the error and use M999 to restart. "

    What's happening? I just got this printer and it's extremely unreliable.
    Thread by: castmemberzack, Apr 20, 2016, 6 replies, in forum: Troubleshooting
  7. castmemberzack
    Thread

    Unanswered Getting blobs/zits in Simplify. What's everyone's settings to get rid of them?

    Just called tech support. They didn't know what blobs or zits are. I'm using simplify3D. I'm a n00b so i'm not really sure what to do. Simplify's...
    Thread by: castmemberzack, Apr 13, 2016, 4 replies, in forum: Troubleshooting
  8. castmemberzack
    Thread

    Solved Something's wrong with my Z-axis

    So i got done printing a fairly large object. I decided to go into matter control and lower the extruder. But I think I press the Z negative...
    Thread by: castmemberzack, Apr 2, 2016, 12 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again