1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Arduino - Extruder Motor Not Working - Robo 3D R1

Discussion in 'Troubleshooting' started by Brock_L, Jun 29, 2016.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    When you install the Arduino IDE it will install the Arduino USB drivers.
     
    #21 mark tomlinson, Jul 18, 2016
  2. Brock_L

    Brock_L New Member

    Joined:
    Feb 28, 2015
    Messages:
    13
    Likes Received:
    3
    Well, I changed out all the stepper drivers and the arduino board. Found out I had two malfunctioning boards to I had to purchase a lot of them until one actually hooked up to my computer so I could flash it. It's fixed and working again, although I'm not entirely sure what the problem was to begin with and what solved it XD
     
    #22 Brock_L, Jul 27, 2016
    Geof likes this.
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Lol sometimes it's better to just accept its fixed :)
     
    #23 Geof, Jul 27, 2016
    Rigmarol likes this.
  4. danzca6

    danzca6 Well-Known Member

    Joined:
    Jul 27, 2015
    Messages:
    2,161
    Likes Received:
    1,077
    Try using a UPS with your printer if your not already. Clean protected power goes a long way with electronics. Oh, and no shuffling your feet on the shag carpet with bunny slippers if your going to touch your printer. Hahaha! Glad to hear it's fixed.
     
    #24 danzca6, Jul 27, 2016
  5. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    @danzca6 are you making fun of my bunny slippers ;-)
     
    #25 Geof, Jul 27, 2016
    danzca6 likes this.
  6. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Only when you wear them outside the house.
     
    #26 mark tomlinson, Jul 28, 2016
    Geof likes this.
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page