1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Auto Bed-leveling Weirdness

Discussion in 'Troubleshooting' started by loft, Jan 21, 2017.

Thread Status:
Not open for further replies.
  1. loft

    loft New Member

    Joined:
    Dec 22, 2016
    Messages:
    9
    Likes Received:
    0
    Im having an issue with prints when using a large part of the surface of the bed.

    The parts in the front of the bed are to close to the glass and causes the extruder to build up plastic on the nozzle. The middle prints are perfect and the rear prints are ok maybe slightly to low.


    I thought auto leveling fixed this kinds of issue? Is there something I am doing wrong or something I can adjust?
     
    #1 loft, Jan 21, 2017
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Auto-leveling will only fix slant in one direction. So the suggestion is to put paper shims under the bed magnets until the bed is level front to back. By level I mean that that it is parallel with the extruder hot end nozzle in the front to back plane. It is commonly referred to as Paper Leveling on this and other forums.
     
    #2 WheresWaldo, Jan 21, 2017
    loft, Geof and mark tomlinson like this.
Thread Status:
Not open for further replies.

Share This Page