1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Connector....

Discussion in 'General Questions' started by SteveDjarrell, Sep 20, 2016.

  1. SteveDjarrell

    SteveDjarrell Active Member

    Joined:
    Jan 9, 2015
    Messages:
    101
    Likes Received:
    40
    Was curious if anyone had either modeled or found a pre-fabricated connector? I want one connector to use for easy disconnects of all extruder end connections. This way I can pull one plug and remove the entire carriage. Was going to model something and add the required pins but wanted to ask first.

    Sent from my SM-G935V using Tapatalk
     
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,586
  3. SteveDjarrell

    SteveDjarrell Active Member

    Joined:
    Jan 9, 2015
    Messages:
    101
    Likes Received:
    40
    Thank you very much. Not sure where my head was at.

    Sent from my SM-G935V using Tapatalk
     
    Geof likes this.

Share This Page