1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Do you need matter control to setup your ROBO 3D?

Discussion in 'General Questions' started by Ajm, Jun 23, 2015.

  1. Ajm

    Ajm New Member

    Joined:
    May 20, 2015
    Messages:
    22
    Likes Received:
    4
    I just ordered my robo 3d and I saw in the setup video that you need to do 2 measurements on the print bed in matter control. Do you have to do this with matter control or can I use repetier host?
     
    #1 Ajm, Jun 23, 2015
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Simply put, don't install MatterControl.
     
    #2 WheresWaldo, Jun 23, 2015
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    You can use whatever software you like (and MatterControl is junk).
     
    #3 mark tomlinson, Jun 24, 2015
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Which setup video? You don't need matter control at all
     
    #4 Mike Kelly, Jun 24, 2015
  5. Ajm

    Ajm New Member

    Joined:
    May 20, 2015
    Messages:
    22
    Likes Received:
    4
    I saw a video on robo 3ds YT channel Ive heard bad things about MC I was hoping not to install it. Thanks
    Alright Thanks.
    Ok Thanks
     
    #5 Ajm, Jun 24, 2015

Share This Page