1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Filament Runout Sensor (FRS) upgrade to Robo R1/R1+

Discussion in 'Mods and Upgrades' started by danzca6, Nov 19, 2016.

  1. robinwudh95

    robinwudh95 New Member

    Joined:
    Dec 27, 2019
    Messages:
    1
    Likes Received:
    0
    Hi, thank you for this, i have a problem, when im printing, the printer no read the z offset of the gcode
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,957
    Likes Received:
    7,344
    Where are you setting it?
    Are you doing the G29? Maybe show us your startup GCode...
     
    Geof likes this.
  3. cleve

    cleve New Member

    Joined:
    Jan 17, 2017
    Messages:
    1
    Likes Received:
    0
    Awesome, i modified the the sensor case as you stated... it will not work very well on light coloured filament. i use an end stop and reverse the polority which work on all fillament ...
     
  4. Scifideity

    Scifideity Member

    Joined:
    Mar 24, 2016
    Messages:
    74
    Likes Received:
    18
    Are the code modifications required for this sensor already built into Marlin 1.1.9 ? I'm finding very similar entries but not a 1:1 match. I'm curious if it's already accounted for if I uncomment the #define FILAMENT_RUNOUT_SENSOR line and the code is just updated from what was needed when this thread posted on Marlin 1.1.0?
     
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,957
    Likes Received:
    7,344
    Geof likes this.
  6. Scifideity

    Scifideity Member

    Joined:
    Mar 24, 2016
    Messages:
    74
    Likes Received:
    18
    Thanks! I did change the pins_RAMPS.h as shown in the guide to pin 20. I got busy and paused messing with it but will try to get it tested out and see how it goes soon.
     

Share This Page