1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved fingers and hands for children

Discussion in 'Troubleshooting' started by Robert Choban, Dec 27, 2014.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    The spring looking thing that connects the z threaded rods to the motors
     
    #21 Mike Kelly, Jan 11, 2015
  2. Robert Choban

    Robert Choban Active Member

    Joined:
    Aug 22, 2014
    Messages:
    279
    Likes Received:
    27
    This is a picture of a finger I'm printing. I have a Robo R1 with enclosed bottom, Hexagon hotend, PLA, temp 199, no supports, no heat on the bed(for now, problem with the bed heater),
    The print looks OK, but I'm wonder if there is something I can do to make it better? The ribbing on the side is not as smooth as other pictures I have see. Is this a ribbing problem that Ziggy is talking about or something else???
     

    Attached Files:

    #22 Robert Choban, Jan 20, 2015
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    If that ribbing is in the Z axis, yes.

    Is it actual ribbing (i.e. feels rough)?
    I can't tell for sure if that is ribbing or if you are just seeing the layers (which can be normal).

    If it is ribbing then @Ziggy has the thread for you.
     
    #23 mark tomlinson, Jan 20, 2015
  4. Robert Choban

    Robert Choban Active Member

    Joined:
    Aug 22, 2014
    Messages:
    279
    Likes Received:
    27
    It does feel rough, thanks for you comment, I will check Ziggy's post
     
    #24 Robert Choban, Jan 20, 2015
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page