1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

First print

Discussion in 'Show and Tell' started by crazyshakespeare, Dec 2, 2015.

  1. crazyshakespeare

    crazyshakespeare Member

    Joined:
    Dec 1, 2015
    Messages:
    35
    Likes Received:
    2
    I have to say, Im pretty impressed....out of box and straight to printing in less than an hr, not to mention the detail is pretty impressive. Any tips or if any of you notice anything in the print please let me know. I do have a question about what would cause the bumps on top rather than a smoother surface?....any ideas?
     

    Attached Files:

    #1 crazyshakespeare, Dec 2, 2015
    Mike Kelly likes this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    Not enough top and bottom layers. The infill is showing through.
    Most slicers default to 2 or 3 top/bottom layers. The default layer height is usually 0.2mm -- do the math.
    Not a lot of material there...
     
    #2 mark tomlinson, Dec 2, 2015

Share This Page