1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved heated bed Maxtemp mess

Discussion in 'Troubleshooting' started by infantryelvis, Jun 9, 2017.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    If everything is hooked up correctly on the new ramps replace the arduino
     
    #21 Geof, Jun 10, 2017
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    If the heater and thermistor physically check out it is either the ramps or arduino
     
    #22 Geof, Jun 10, 2017
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Then one of the plugs is reversed.

    The NOTHING part bothers me since that almost has to be the RAMPS since it is the common point. If either motor is swapped it will spin the opposite direction. Not spinning means it is not getting a signal.
     
    #23 mark tomlinson, Jun 11, 2017
    Geof likes this.
  4. infantryelvis

    infantryelvis New Member

    Joined:
    Jun 9, 2017
    Messages:
    14
    Likes Received:
    1
    Alright my Arduino board just showed up, I plugged it in to my pc and it seemed to auto update the board does this sound right? Also all of the Robo firmware links that I have found seem to be broken any updated links that I may have overlooked?
     
    #24 infantryelvis, Jun 17, 2017
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    #25 mark tomlinson, Jun 17, 2017
    infantryelvis likes this.
  6. infantryelvis

    infantryelvis New Member

    Joined:
    Jun 9, 2017
    Messages:
    14
    Likes Received:
    1
    Eureka!!! so Im printing again, However I seem to have some serious y axis drag causing the belt to skip a couple teeth and throw the print off but the core issue is resolved.

    Recap- If the heatbed wire harness gets munched and the power and ground touch causing this issue you have fried both boards. Thank you everyone for the help and patience.
     
    #26 infantryelvis, Jun 17, 2017
    mark tomlinson likes this.
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page