1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

How can i fix bed wobble?

Discussion in 'Troubleshooting' started by MWDK, Sep 18, 2018.

  1. MWDK

    MWDK New Member

    Joined:
    Jan 3, 2018
    Messages:
    19
    Likes Received:
    3
    See video here:
     
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    That is not wobble I see, it is pressing down on the bed in the front.// This is a consequence of the design of the printer, you are only supported on the back edge so the front is pressed down when the extrude is being placed in that position.
     
  3. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,729
    Likes Received:
    2,330
    if you push on the corners of the bed (when not printing) does the bed move? If so raise the side that moves until it doensn't. Relevel your bed. its possible its tweaked enough where you are lifting one corner (or corners). I've been able to fix it by a proper leveling. having 4 adjusters instead of 3 does not help this situation.
     

Share This Page