1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

"Max Temp Bed" on LCD only 65 degrees

Discussion in 'Troubleshooting' started by William, Oct 14, 2014.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. William

    William New Member

    Joined:
    Jul 25, 2013
    Messages:
    105
    Likes Received:
    21
    I was able to finish the print. I had to figure the position and look in the G-code to find where I was and deleted previous steps. It worked a lot better than I thought it would. Thanks for the help.
     
    #21 William, Oct 15, 2014
    2 people like this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Sweet. That is a tough thing to get to work.
     
    #22 mark tomlinson, Oct 16, 2014
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Impressive stuff. Mostly that the robo is reliable enough to do that!
     
    #23 Mike Kelly, Oct 16, 2014
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page