1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

NinjaFlex

Discussion in 'Printing Filament' started by Jack_Adamczuk, Jun 5, 2014.

  1. Jack_Adamczuk

    Jack_Adamczuk New Member

    Joined:
    May 6, 2014
    Messages:
    29
    Likes Received:
    12
    RoBo 3D R1 oldest version. NO HARDWARE MODS !!

    The older version of the printer prints perfectly on NinjaFlex filament. I thought it was a hardware issue. It turned out that the settings allow you to get a fairly good prints.
    NOTE All settings are modified head diameter - 0.45 (only software change).



    Please test it and give info :)
    Sory my english is not very good :)
     

    Attached Files:

    #1 Jack_Adamczuk, Jun 5, 2014
    2 people like this.
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    What speed did you print at?
     
    #2 Mike Kelly, Jun 5, 2014
  3. Jack_Adamczuk

    Jack_Adamczuk New Member

    Joined:
    May 6, 2014
    Messages:
    29
    Likes Received:
    12
    Everything is in slice setting file, i thing it was 10, check file, i do not remeber. Movie is in real time.
     
    #3 Jack_Adamczuk, Jun 5, 2014
  4. Jack_Adamczuk

    Jack_Adamczuk New Member

    Joined:
    May 6, 2014
    Messages:
    29
    Likes Received:
    12
    I update slice setting file. See new print ;) - NinjaFlex
     

    Attached Files:

    #4 Jack_Adamczuk, Jun 5, 2014
    5 people like this.
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Awesome! Thank you.
    I will translate these settings into Simplyfy3D and give it a shot.
    I have not printed a larger object yet since getting the tube installed and the feed working.
     
    #5 mark tomlinson, Jun 6, 2014
  6. Printed Solid

    Printed Solid Volunteer Admin
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    1,605
    Likes Received:
    1,003
    @Jack_Adamczuk: You made NO mods to the extruder? How did you prevent the filament from buckling? Do you think it was just the slow speed?
     
    #6 Printed Solid, Jun 8, 2014
  7. Jack_Adamczuk

    Jack_Adamczuk New Member

    Joined:
    May 6, 2014
    Messages:
    29
    Likes Received:
    12
    Once speed, secound head diameter shoud be 0.45, and other slice setting. Everything is in "slicefile".
     
    #7 Jack_Adamczuk, Jun 8, 2014
  8. Robb

    Robb Member

    Joined:
    May 14, 2014
    Messages:
    80
    Likes Received:
    7
    Did you add any tubbing so the Ninja flex doesn't bunch up between the hobble bolt and the hot end? If so whet did you use?
     
    #8 Robb, Jun 8, 2014

Share This Page