1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Print randomly stops due to firmware.

Discussion in 'Troubleshooting' started by mclemens7, Jul 23, 2017.

  1. mclemens7

    mclemens7 Member

    Joined:
    Jan 29, 2017
    Messages:
    165
    Likes Received:
    6
    Hello, I’m using simplify 3d for my prints and the prints randomly stop. I then tried using sd cards and that still stopped too. So I then looked at the log screen in simplify 3d and it says there is a firmware error. I then reuploaded the firmware, but the same thing happened again. Please help and any ideas ?
     
    #1 mclemens7, Jul 23, 2017
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Look further back in the log, the firmware message was just a generic one and the actual error is much further back. There was no need to re-upload the firmware.
     
    #2 WheresWaldo, Jul 23, 2017
  3. mclemens7

    mclemens7 Member

    Joined:
    Jan 29, 2017
    Messages:
    165
    Likes Received:
    6
    So is there a log I could find because the log I saw was very limited
     
    #3 mclemens7, Jul 24, 2017
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    In the gcode.console/log/communication tab of your slicer when printing via usb
     
    #4 Geof, Jul 24, 2017
  5. mclemens7

    mclemens7 Member

    Joined:
    Jan 29, 2017
    Messages:
    165
    Likes Received:
    6
    where would i find that
     
    #5 mclemens7, Jul 24, 2017
  6. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    #6 mark tomlinson, Jul 24, 2017
  7. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    Simplify3D support is probably a better place to ask Simplify3D specific questions.
     
    #7 mark tomlinson, Jul 24, 2017

Share This Page