1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Problem with extruder fan

Discussion in 'Troubleshooting' started by Robert Choban, Sep 3, 2014.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Gonna call you the fan-innator. The fan assassin. something cool like that :)
     
    #21 mark tomlinson, Sep 22, 2014
  2. mediaguru

    mediaguru Member

    Joined:
    Nov 10, 2014
    Messages:
    149
    Likes Received:
    17
    Looks like I have this issue, as well. I got a new 25mm fan with my replacement hexagon, fortunately... but unfortunately, the wire doesn't look long enough to reach (haven't measured yet), and I don't even know where the problem is happening (board, wiring, or fan itself)...

    would it be possible to just cut, strip, and crimp the old wiring onto the new fan? If it's the fan itself, that would be the easiest fix...
     
    #22 mediaguru, Dec 24, 2014
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,276
    Yes, probably the fan. If you get power the fan should turn on
     
    #23 Mike Kelly, Dec 24, 2014
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page