1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Robo Not Booting AND Printbed Already Lowered

Discussion in 'Troubleshooting' started by One Wing Ninja, Jul 24, 2018.

  1. One Wing Ninja

    One Wing Ninja New Member

    Joined:
    Jul 24, 2018
    Messages:
    2
    Likes Received:
    1
    Hi,
    My robo r2 is not booting (it only shows a black screen. I want to try to change the micro SD card on the raspberry pi, but my print bed it already lowered and covering the access area. Does anybody know how to move the print bed while the robo r2 is off or not booted, or if there is another way to access the raspberry pi?
     
    #1 One Wing Ninja, Jul 24, 2018
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    power off the machine and turn the threaded rod by hand. Wear gloves, its greasy. Also moved to R2 Section.
     
    #2 Geof, Jul 24, 2018
    WheresWaldo likes this.
  3. One Wing Ninja

    One Wing Ninja New Member

    Joined:
    Jul 24, 2018
    Messages:
    2
    Likes Received:
    1
    thanks!
     
    #3 One Wing Ninja, Jul 24, 2018
    Geof likes this.

Share This Page