1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Something came loose

Discussion in 'General Questions' started by Carlos Herrera, May 11, 2019.

  1. Carlos Herrera

    Carlos Herrera New Member

    Joined:
    May 11, 2019
    Messages:
    4
    Likes Received:
    0
    hello, I have noticed that this cylinder has come loose. When it does I get the printing error. Any suggestions? I can snap it back in but after a few prints, it comes loose.
     

    Attached Files:

  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    20,763
    Likes Received:
    6,951
    Hmm, I'll let @Geof or @WheresWaldo comment since they have R2 machines.

    It may need a bit of glue to help keep it in place
     
    Carlos Herrera likes this.
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,724
    Likes Received:
    3,490
    I thought those were press fit, never seen one apart. That bearing is for the bed guide rail.
     
  4. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,546
    Likes Received:
    2,255
    Im not around my printers due to being in CA until the 24th but also have not seen that happen. If it was mine id get some bearing mount, put a few dabs on the outside of the bearing and push it back into the housing (like the other side in your picture). If the machine is under warranty contact support
     

Share This Page