1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Troubles Printing Ninjaflex

Discussion in 'Printing Filament' started by Wesotn, Aug 5, 2016.

  1. Wesotn

    Wesotn New Member

    Joined:
    Dec 30, 2015
    Messages:
    16
    Likes Received:
    1
    Has anyone ever had any luck with printing ninjaflex? I am trying to print with it and I did some modifications with some tubing so it would directly extrude and have as little contact with the gears as possible but none of it has worked. It still is getting caught in the gears and I have used tubing to help guide it as close to the tubes as possible. I'm printing as slow as 5 mm/s and still having issues. Anyone have any sort of workarounds?
     
    #1 Wesotn, Aug 5, 2016
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I couldnt print with ninjaflex with the hexagon hotend, some have. I was able to do semiflex but very slow. I ended up upgrading to the e3dv6
     
    #2 Geof, Aug 6, 2016
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #3 mark tomlinson, Aug 6, 2016
    Geof likes this.

Share This Page