1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Z-axis end stop does not work anmore

Discussion in 'Troubleshooting' started by ikre, Jun 20, 2016.

Page 2 of 2
  1. ikre

    ikre New Member

    Joined:
    May 20, 2014
    Messages:
    24
    Likes Received:
    3
    I FOUND THE PROBLEM!!!!!!

    i wanted to update the system after my first print this week....i used the wrong firmware.....flashed the R1 old firmware back and it works again...printed the auto lvl block. First 3-4 layers have warped, but the rest is good.

    So starting to build my auto lvl bed.

    thanks guys....this was something you could not have known....

    Iwan
     
    #21 ikre, Jun 24, 2016
    Geof and mark tomlinson like this.
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Ah,yea... until you reconfigure the switches for autoleveling... you can't use that firmware :)
    Good catch and thanks for closing the loop.
     
    #22 mark tomlinson, Jun 24, 2016
    Geof likes this.
Page 2 of 2

Share This Page