1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Z-Axis not responding.

Discussion in 'Troubleshooting' started by Sylva, Dec 18, 2017.

Thread Status:
Not open for further replies.
Page 2 of 2
  1. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Where did you get that firmware?
    It is not from this forum nor is it direct from Robo. I know this because the line that says #define DEFAULT_AXIS_STEPS_PER_UNIT { 80, 80, 4000, 500 } is not in my firmware edits nor is it in any of Robo's firmware.
     
    #21 WheresWaldo, Dec 30, 2017
  2. Sylva

    Sylva Member

    Joined:
    Nov 11, 2016
    Messages:
    37
    Likes Received:
    4
    I don't remember the site I got it from but when I go to download it from the robo limk, the site 404s

    Sent from my SM-G930V using Tapatalk
     
    #22 Sylva, Dec 30, 2017
  3. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    #23 WheresWaldo, Dec 30, 2017
  4. Sylva

    Sylva Member

    Joined:
    Nov 11, 2016
    Messages:
    37
    Likes Received:
    4

    Thanks, I trying uploading the r1plus firmware you hotlinkd, and Im getting this error. I didn't change anything to it yet. just opened and hit upload.

    request for member 'position' in '* pos', which is of non-class type 'fpos_t {aka long long int}'
     
    #24 Sylva, Dec 30, 2017
  5. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    #25 WheresWaldo, Dec 30, 2017
    mark tomlinson likes this.
  6. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Search the forum for SDBASE.zip
    I have attached it to half-a-dozen threads regarding this already.
     
    #26 mark tomlinson, Dec 30, 2017
  7. Sylva

    Sylva Member

    Joined:
    Nov 11, 2016
    Messages:
    37
    Likes Received:
    4
    Tested the homing after uploading the firmware you linked and works great now!

    Thank you guys for your help! I now have both printers working great.
     
    #27 Sylva, Dec 31, 2017
    WheresWaldo, mark tomlinson and Geof like this.
Page 2 of 2
Thread Status:
Not open for further replies.

Share This Page