Separate names with a comma.
Are you talking about how to create something like what is sold here?
Maybe you read this article,...
The argument is flawed, because Creality had done exactly what the license terms state for several of their machines. Two of the machines that use...
The part that is being missed in all this is the behind-the-scenes bit where the Marlin devs pulled their usual "you are an incompetent moron, do...
It's almost as though closing threads after X amount of time without a post is a good idea.
But does it hold water?
Also printed this calibration test.
Everywhere there is a stated dimension, that dimension turns out to be accurate...
Printed this thing.
Welp, Printrbot is dead, for anyone that doesn't already know it.
Just printed the old planetary gear print (that my old R1 could never print without fusing the gears together). As soon as I figure out how to...
Updating with some prints (I haven't forgotten about the thread).
Slicer settings same as in the OP, but with a filament I haven't used before...
There used to be a thread here where someone went over all...
I've used it, but not with any Robo-brand printer.
I ended up disabling it because I didn't like the unnecessary movements it introduced when...
Seconding this, don't wait to see what support another person gets. File your own support ticket and stay on top of it.
I'd be interested in knowing just how much of that printer is built entirely of off-the-shelf parts, but not enough to buy/build one myself.
It should be noted here that just because the printer being discussed doesn't have the adjustment being mentioned, does not mean that the...