1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by joea

  1. joea
    Post

    Answered Shift in +X and +Y mid print.

    I've had shifts before, but it is pretty illusive. In this case that "glob" on the side may be the culprit if it had hardened and was hit....
    Post by: joea, May 21, 2023 in forum: Troubleshooting
  2. joea
    Post

    Answered Homing Z show -001.0 on LCD

    Yes. I pondered where to put it and opted for Prusa. Only thing in Ocotprint, is what what I put in for a "cancelled" job.
    Post by: joea, May 21, 2023 in forum: Troubleshooting
  3. joea
    Post

    Solved Prusa Slicer "adaptive Cubic" infill with R1

    I've found a partial answer in their documentation which suggests the cubic and adaptive cubic are somewhat problematic for some uses. I found...
    Post by: joea, May 20, 2023 in forum: Troubleshooting
  4. joea
    Thread

    Answered Shift in +X and +Y mid print.

    To add to my current frustrations, after finally getting Z offset, bed and filament temperature reasonably "dialed in", about 1/3 way through the...
    Thread by: joea, May 20, 2023, 2 replies, in forum: Troubleshooting
  5. joea
    Post

    Answered Homing Z show -001.0 on LCD

    Well it is an R1 "plus"-ish. Meaning Ive done the lead screw mods and "stuff". It has no "bottom cover", so it is a pretty early version. The...
    Post by: joea, May 20, 2023 in forum: Troubleshooting
  6. joea
    Post

    Solved Z offset (?) in Prusa Slicer?

    Trial and error have given me a reasonable offset.
    Post by: joea, May 20, 2023 in forum: Troubleshooting
  7. joea
    Thread

    Answered Homing Z show -001.0 on LCD

    Chasing my tail once again, after making another attempt at manually leveling the bed (x axis, leadscrew and paper method) and doing a Z "home",...
    Thread by: joea, May 20, 2023, 4 replies, in forum: Troubleshooting
  8. joea
    Thread

    Solved Prusa Slicer "adaptive Cubic" infill with R1

    Any experience here with using Prusa Slicer 2.5.2 "adaptive Cubic" infill? It just makes a mess, in my testing.
    Thread by: joea, May 18, 2023, 1 replies, in forum: Troubleshooting
  9. joea
    Thread

    Solved Z offset (?) in Prusa Slicer?

    Been experimenting with Prusa Slicer, v 2.52. While my very first print seemed to do well, since then various problems. One may be the first...
    Thread by: joea, May 18, 2023, 2 replies, in forum: Troubleshooting
  10. joea
    Post

    Solved Manually extruding filament, makes a loop.

    Cleaning the exterior of the nozzle with a soft brass bristle brush seems to have resolved this.
    Post by: joea, May 18, 2023 in forum: Troubleshooting
  11. joea
    Thread

    Solved Manually extruding filament, makes a loop.

    Trying to resolve recent print problems, when manually extruding filament, it comes out as a "loop" rather than a straight extrusion. Nozzle...
    Thread by: joea, May 17, 2023, 2 replies, in forum: Troubleshooting