1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by MOwens5150

  1. MOwens5150
    Post

    Thermistor for Robo R1

    I use a the M3 Stud sensor...
    Post by: MOwens5150, Apr 20, 2017 in forum: Mods and Upgrades
  2. MOwens5150
    Post

    Solved Tried to update Firmware to V2

    Thanks to your advice I double checked evrything again. I found the issue was I had the new firmware on my network drive and even though I had...
    Post by: MOwens5150, Mar 28, 2017 in forum: Troubleshooting
  3. MOwens5150
    Thread

    Solved Tried to update Firmware to V2

    All, I have been trying to get the new software "Cura for Robo" to work on my R1+. It would not recognize my R1+. I downloaded Arduino 1.6.9...
    Thread by: MOwens5150, Mar 28, 2017, 3 replies, in forum: Troubleshooting
  4. MOwens5150
    Thread

    Matter Control software settings for different nozzle sizes

    All, I am looking for a cheat sheet on how to easily create different Quality Settings for nozzle sizes such as .3 & .6. Could anyone point me...
    Thread by: MOwens5150, Mar 23, 2017, 1 replies, in forum: Software
  5. MOwens5150
    Post

    Solved Screw threads print bad

    WheresWaldo WheresWaldo, what settings did you use?
    Post by: MOwens5150, Dec 17, 2016 in forum: Troubleshooting
  6. MOwens5150
    Thread

    Solved Screw threads print bad

    I am printing a big screw used in a headphone holder and the threads blob up. Any ideas? Anything else I print doesn't have these issues.
    Thread by: MOwens5150, Dec 16, 2016, 7 replies, in forum: Troubleshooting
  7. MOwens5150
    Thread

    Unresolved Print Quality issues

    Ok I just installed a new wire harness sent to me by Robo and had a tough time getting printer to print on print bed. Had a few rounds where...
    Thread by: MOwens5150, Feb 22, 2016, 1 replies, in forum: Troubleshooting
  8. MOwens5150
    Post

    Answered Wire harness issue

    Thanks all Robo is sending me a new harness.
    Post by: MOwens5150, Feb 2, 2016 in forum: Troubleshooting
  9. MOwens5150
    Post

    Answered Wire harness issue

    Adding picture
    Post by: MOwens5150, Jan 30, 2016 in forum: Troubleshooting
  10. MOwens5150
    Thread

    Answered Wire harness issue

    The green wire came out of the harness that goes to the print head motor. The metal piece is still in the harness. How do I get it out to fix or...
    Thread by: MOwens5150, Jan 30, 2016, 5 replies, in forum: Troubleshooting