1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. ParamedicStan
    Thread

    Looking for a color...

    Hey Folks... I'm looking for some green filament, PLA or PetG, in Ranger Green. I'm doing some work for are tactical units. If anyone could point...
    Thread by: ParamedicStan, Jan 13, 2017, 2 replies, in forum: Printing Filament
  2. ParamedicStan
    Thread

    Unanswered How much better can I get....

    OK... I'm running a Robo3d r1+ for almost the past year. I have learned a lot about it, like replacing the hot end or nozzles, how to keep it...
    Thread by: ParamedicStan, Aug 7, 2016, 3 replies, in forum: General Questions
  3. ParamedicStan
    Thread

    taulman T-glass Green 1.75mm NOT....

    So..... 6 months ago I purchased a roll of T-glass Green 1.75mm. I was very new to printing and I did not know what I was getting into with this...
    Thread by: ParamedicStan, May 12, 2016, 2 replies, in forum: Printing Filament
  4. ParamedicStan
    Post

    Solved Hardware or Software Issue

    Thanks for the info...
    Post by: ParamedicStan, Apr 14, 2016 in forum: Troubleshooting
  5. ParamedicStan
    Thread

    Solved Hardware or Software Issue

    [ATTACH] So I was printing all three pieces at the same time and this happen.... clearly a layer shift but only on the 2nd and 3rd pieces,...
    Thread by: ParamedicStan, Apr 13, 2016, 3 replies, in forum: Troubleshooting
  6. ParamedicStan
    Post

    Ok, Ok, Ok I just pulled the Trigger!!!!!

    I did pay duties and taxes at the boarder, I cleared it my self so it was taxes only no duties.
    Post by: ParamedicStan, Mar 9, 2016 in forum: Canada
  7. ParamedicStan
    Post

    Ok, Ok, Ok I just pulled the Trigger!!!!!

    I ordered it directly from ROBO3d. No issues.
    Post by: ParamedicStan, Mar 3, 2016 in forum: Canada
  8. ParamedicStan
    Post

    Stan's Printer...

    I only wish it was an hyrdo issue. The Pinter and my raspberry Pi are protected via a surg and UPS, the Pi never stopped, the leds turned off and...
    Post by: ParamedicStan, Feb 11, 2016 in forum: Show and Tell
  9. ParamedicStan
    Post

    Stan's Printer...

    So after a few prints today we lost power... it looks like the power supply die.... after 25 to 30min is great printing it "BROWNS OUT" than...
    Post by: ParamedicStan, Feb 11, 2016 in forum: Show and Tell
  10. ParamedicStan
    Thread

    PLA Filaments.ca Has another used it....

    So get filament in Canada is starts to become expensive.... ex. Ninja Flex is like $75 to $100 a roll plus shipping and exchange it's killing me....
    Thread by: ParamedicStan, Feb 11, 2016, 1 replies, in forum: Printing Filament
  11. ParamedicStan
    Post

    Stan's Printer...

    So after a great day of dressing/upgrading up my Robo3D R1+... Started with a new webcam, Logitech c270, Raspberry Pi2 with Octoprint on a 15"...
    Post by: ParamedicStan, Feb 11, 2016 in forum: Show and Tell
Showing results 1 to 11 of 11
Search Again