1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Luis Alberto
    Thread

    Unresolved Settings on Cura for printing TPE

    Greetings guys, I've been printing some pieces on this flexible filament without serious problems, I think; no jamming or clogs, printed that part...
    Thread by: Luis Alberto, Nov 10, 2016, 0 replies, in forum: Troubleshooting
  2. Luis Alberto
    Thread

    Unresolved My printbed stops heating.

    Greetings, Im back again. Just like the title says, my printbed wont heat. The sensor placed there seems to be ok cause it reads the temperature,...
    Thread by: Luis Alberto, Oct 7, 2016, 33 replies, in forum: Troubleshooting
  3. Luis Alberto
    Thread

    Solved Please help me. My printer keeps doing this.

    This is what happens, just prints the skirt and the first layer and when have to go to the next one stops extruding. At first happened printing...
    Thread by: Luis Alberto, Sep 29, 2016, 10 replies, in forum: Troubleshooting
  4. Luis Alberto
    Thread

    Unresolved Cant print from Matter Control

    Greetings.Ive had some troubles printing from Matter Control environment, after printing the first layers filament stops flowing, the extruder...
    Thread by: Luis Alberto, Sep 27, 2016, 6 replies, in forum: Troubleshooting
  5. Luis Alberto
    Thread

    Unresolved Clogged extruder

    Get the rest of it out. I am curious if the hole is threaded. If so, you could always use one of these to replace it....
    Thread by: Luis Alberto, Sep 13, 2016, 7 replies, in forum: Troubleshooting
  6. Luis Alberto
    Thread

    Solved Failres on print bed and extruder. Please help me.

    Greetings. Let the printer working on an 10 hour piece on ABS, checked for the first layer and seemed pretty well, leaved the office and the next...
    Thread by: Luis Alberto, Aug 31, 2016, 37 replies, in forum: Troubleshooting
  7. Luis Alberto
    Thread

    Unresolved Tips to improve the first layer of my prints

    Greetings. Could you give any advice to improve the first layer of my prints? Here is the situation, when the print job has finished and remove...
    Thread by: Luis Alberto, Aug 23, 2016, 2 replies, in forum: Troubleshooting
  8. Luis Alberto
    Thread

    Solved Problem with bumps near corners

    Ive been working with the ROBO3D for a couple of months. Had no problems with the first print jobs, but now there is one in particular; if Im...
    Thread by: Luis Alberto, Aug 15, 2016, 20 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again