1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Lifting edge and dragging nozzle across bed

Discussion in 'Troubleshooting' started by LabMinion, Feb 3, 2015.

Page 3 of 3
  1. robert sanchez

    robert sanchez Active Member

    Joined:
    Oct 9, 2014
    Messages:
    320
    Likes Received:
    160
    #41 robert sanchez, Oct 15, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Whichever program you are slicing with should have a configuration section called "Startup GCode" and you add it there for it to always be included.
     
    #42 mark tomlinson, Oct 16, 2015
  3. Joshua R. Taylor

    Joshua R. Taylor Member

    Joined:
    Aug 15, 2015
    Messages:
    37
    Likes Received:
    4
    I'm using MatterControler 1.4
     
    #43 Joshua R. Taylor, Oct 17, 2015
  4. Joshua R. Taylor

    Joshua R. Taylor Member

    Joined:
    Aug 15, 2015
    Messages:
    37
    Likes Received:
    4
    In Matter Controler 1.4....any idea where this is?
     
    #44 Joshua R. Taylor, Oct 17, 2015
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    No, but someone who uses it can chime in.
     
    #45 mark tomlinson, Oct 17, 2015
  6. robert sanchez

    robert sanchez Active Member

    Joined:
    Oct 9, 2014
    Messages:
    320
    Likes Received:
    160
    Sorry I don't use matter control. If I get time tonight I'll load it and play around with it.
     
    #46 robert sanchez, Oct 17, 2015
  7. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    #47 Mike Kelly, Oct 21, 2015
Page 3 of 3

Share This Page