1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Robo 3D r1 plus

Discussion in 'Projects' started by tom1441, Aug 18, 2017.

  1. tom1441

    tom1441 New Member

    Joined:
    Aug 3, 2016
    Messages:
    21
    Likes Received:
    1
    I'm going to be replacing my arduino and ramps soon what steps do I need to do after replacing these parts. Is there anything I need to down load to get my printer back on like?


    Sent from my iPad using Tapatalk
     
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    21,117
    Likes Received:
    6,997
    Thread moved to R1 section.
     
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    21,117
    Likes Received:
    6,997
    If you replace the Arduino you need to reload the firmware.
    If you only replace the RAMPS you do not.
     
  4. tom1441

    tom1441 New Member

    Joined:
    Aug 3, 2016
    Messages:
    21
    Likes Received:
    1
    Thank you I will be replacing both ordered from robo 3d


    Sent from my iPad using Tapatalk
     
    mark tomlinson likes this.
  5. tom1441

    tom1441 New Member

    Joined:
    Aug 3, 2016
    Messages:
    21
    Likes Received:
    1
    Do you have a link for the firmware
     

Share This Page