1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Starting to get frustrated

Discussion in 'Troubleshooting' started by trevely, Aug 5, 2018.

Thread Status:
Not open for further replies.
  1. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,583
    @Jerome Helbert I do the same on my printer, brass brush nozzle right after print is done.
     
  2. trevely

    trevely New Member

    Joined:
    May 4, 2018
    Messages:
    28
    Likes Received:
    10
    I would like to thank everyone for there help as I'm back to printing. The brass brush is a great idea, heated up the nozzle and the plastic started coming off no problem. Thanks for all the great suggestions, I appreciate it.
     
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page