Separate names with a comma.
Any luck finding the board?
I have already converted, but I'm just very unhappy with it. Prints are too hard to remove, some material is still on there and won't...
Geof, that would be greatly appreciated. If you find the Pogo pin board, I'll take it. (mine got damaged in a move, I believe . . . should have...
I would actually need the little board with the pins too. I was just going to build it up with solder or something, but if someone had that...
Anybody wanna sell their original R2 bed? The one that used to detach . . . .
My little spring contacts broke, and instead of a new one, they...
The new bed removes the ability to easily remove the bed at print complete. You'd have to pull the plug to remove the bed, and it's not easy to...
Looks great! Well done!
The dual head extruder module Robo3D is using on the home page to sell the R2 to people, making them think it comes with two print heads.
Anyone still have this working, or ever get it working? I can't find the "My Robo" skill on Alexa . . . . .
Will Robo be selling the updated fan shroud? I'd rather buy one than print one myself (seems counter-intuitive, I know)
Lexan Sheet - Polycarbonate - .030"
from amazon cut to fit.
I see all these methods to keep our filament in a dry environment.
What I notice when my filament spools sit out on the desk for a few months at...
SamIdea 9Pairs 4Pole 5.08mm Plug Type Pitch PCB Mount Screw Terminal Block Kit with Right Angle Pin, AC 300V 15A(IEC)/10A(UL)...
If I were going to buy that plug for the board, what would I look for on Amazon?
I have success with ABS while using a home made hood. Foam board all around, and two hard-plastic sheet windows on front and side.
I have noticed that the camera view in OcotPrint using the Robo3d Theme the image is rotated about 15 degrees CCW. By that I mean it looks level....
I got a brand new door because mine was scratched during shipping. Then started noticing these vertical scratches a few days later. These...
I'm gonna check all of mine tonight. Already had one of the screws vibrate loose under the bed and fall off.
Hope you get this fixed.
Never mind, you mentioned you are using the 12V light strip.
So I'm guessing the LED's won't burn out, and they are safe on a 24V source?
Good to know. Are you using 24V LEDs or do the 12V ones all over Amazon work fine?